Der Blätterkatalog benötigt Javascript.
Bitte aktivieren Sie Javascript in Ihren Browser-Einstellungen.
The Blätterkatalog requires Javascript.
Please activate Javascript in your browser settings.
13 EN Copyright © 2018 SOMFY ACTIVITES SA Société Anonyme All rights reserved ILMO 2 40 WT 1 Prerequisite information 13 1 1 Area of application 13 1 2 Liability 13 2 Installation 14 2 1 Installation 14 2 2 Wiring 15 2 3 Commissioning 16 2 4 Tips and recommendations for installation 16 3 Use and maintenance 17 3 1 Raising and lowering the roller shutter 17 3 2 Obstacle detection 17 3 3 Antifreeze protection 18 4 Tips and recommendations for use 18 5 Technical data 18 The ILMO 2 40 WT is a nonadjustable motor a simple connection is all that is required The ILMO 2 40 WT programs its end limits automatically The ILMO 2 40 WT can be mounted either on the right or the left It can be controlled from a control point with a fixed position or momentary actiontype switch The ILMO 2 40 WT is equipped with - obstacle protection to protect the roller shutter when it is being lowered - antifreeze protection to protect the roller shutter when it is being raised CONTENTS ORIGINAL GUIDE These instructions apply to all ILMO 2 40 WT drives across all torque speed ranges 1 PREREQUISITE INFORMATION 1 1 AREA OF APPLICATION The ilmo 2 40 drive is designed to drive all types of roller shutters equipped with rigid links and stops which fulfil at least one of the following conditions - The motorised product is controlled by a switch without a locking device see the attached Safety instructions document - When deployed all parts of the motorised product are more than 2 50 m above ground or any other permanent access level - The apron of the roller shutter can be raised by 4 cm if a force of 150 Nis applied upwards on the final slat placed 16 cm from its fullydeployed position If the roller shutter has slats which can open the openings must not allow a pin of diameter 5 mm to pass through 1 2 LIABILITY Please read these instructions carefully before installing and using the ILMO 2 40 drive In addition to following the instructions given in this guide the instructions detailed in the attached Safety instructions document must also be observed The ILMO 2 40 WT drive must be installed by a motorisation and home automation professional according to instructions from Somfy and the regulations applicable in the country in which it is commissioned It is prohibited to use the ILMO 2 40 WT drive outside the field of application described above Such use and any failure to comply with the instructions given in this guide and in the attached Safety instructions document absolves Somfy of any liability and invalidates the warranty The installer must inform its customers of the operating and maintenance conditions for the ILMO 2 40 WT drive and must provide them with the instructions for use and maintenance and the attached Safety instructions document after installing the ILMO 2 40 WT drive Any After-Sales Service operation on the ILMO 2 40 WT drive must be performed by a motorisation and home automation professional If in doubt when installing the ILMO 2 40 WT drive or to obtain additional information contact a Somfy adviser or go to the website www somfy com Safety warning Caution Information