Der Blätterkatalog benötigt Javascript.
Bitte aktivieren Sie Javascript in Ihren Browser-Einstellungen.
The Blätterkatalog requires Javascript.
Please activate Javascript in your browser settings.
14 EN Copyright © 2018 SOMFY ACTIVITES SA Société Anonyme All rights reserved ILMO 2 40 WT 2 INSTALLATION Instructions which must be followed by the motorisation and home automation professional installing the ILMO 2 40 WT drive Never drop knock drill or submerge the drive Install a separate control point for each motorisation Never connect 2 control points to a single motor 2 1 INSTALLATION Check the strength of the roller shutter and its fittings Check that the drive used is suitable for the size of roller shutter to avoid the risk of damaging the roller shutter and or the Somfy product For information about the compatibility of the drive with the roller shutter and accessories contact the roller shutter manufacturer or Somfy 2 1 1 Preparing the drive Check that the inner diameter of the tube is 37 mm or greater 1 Fit the accessories required to integrate the motorisation in the roller tube • Either fit the drive wheel a on the drive • Or fit the crown b and the drive wheel c on the drive 2 Measure the length L1 between the inner edge of the motorisation head and the rim of the drive wheel 2 1 2 Tube preparation Install a ILMO 2 40 WT motor in a roller tube with a minimum thickness of 0 5 mm and a smooth inner surface with no welding crimping folding etc inside the tube 1 Cut the roller tube to the required length depending on the motorised product 2 Deburr the roller tube and remove the swarf 3 For smooth roller tubes cut a notch with the following measurements d e Ø 40 x 1 5 mm 7 mm 8 5 mm Ø 40 x 1 mm 6 mm 8 5 mm 2 1 3 Drive tube assembly 1 Slide the motor into the roller tube For smooth roller tubes position the notch previously cut on the crown 2 Attach the roller tube to the drive wheel with three steel pop rivets Ø 4 mm placed at least 5 mm from the far end of the drive wheel L1 - 5 and no more than 15 mm from the far end of the drive wheel L1 - 15 The screws or pop rivets must only be attached to the drive wheel and not to the motor 1 L1 L1 … L1 L1 … 2 Ø > 37 mm c b L1 L1 … Ø 37 mm a 3 1 2 d e L1 15 5 1 2