Der Blätterkatalog benötigt Javascript.
Bitte aktivieren Sie Javascript in Ihren Browser-Einstellungen.
The Blätterkatalog requires Javascript.
Please activate Javascript in your browser settings.
3 2 5 Area lighting operation Area lighting comes on with the motor and goes out 60 seconds a6er the motor has come to a complete stop If a remote control is programmed to control the lighting it operates as follows With a 2 or 4 button remote control With a 3-button remote control 3 2 6 Operation in sequential mode with automatic closing a>er time delay The door closes automatically a6er a timeout programmed during installation Anew command during this timeout cancels automatic closure and the door remains open The following command causes the door to close 3 2 7 Operation using the backup battery If a backup battery is installed the motorisation will work even during a power outage Operation is then activated under the following conditions • Reduced and constant speed • The additional devices photoelectric cells orange light wired code keypad etc do not operate Battery specifications • Battery life 24 hours 3 operating cycles depending on the weight of the door • Recharging time 48 hours • Service life before replacement Approximately 3 years 3 3 Adding Keygo io remote controls This operation is used to copy the function of a button on a memorised Keygo io remote control to a button on a new Keygo io remote control 2s 1 2 3 4 A B Remote control “A” “source” remote control already memorised Remote control “B” “target” remote control to be memorised For example if the button on remote control Aopens the door fully the button on the new remote control Bwill also open the door fully 3 4 Operation of the gate safety Opening the pedestrian gate integrated into the garage door prevents the garage door from moving The integrated lighting is activated intermittently for 30 seconds 3 5 Emergency manual back release mode The Dexxo Smart io is equipped with a manual back release device which makes it possible to operate the door manually for example in the event of an electrical fault This device must be able to be accessed easily at a maximum of 1 80 m from the ground 1 Disengaging the drive Pull on the cord until the door drive system is released 2 Manual manipulation of the door This is possible as the drive system is released 3 Reengaging the drive Move the door manually until the drive mechanism locks on the transmission rail Attention When releasing the drive an incorrect balance may result in sudden movements which may be dangerous Only use the cord to release the drive Never use the cord to manipulate the door manually It is essential that the drive is reengaged before any new commands 4 MAINTENANCE 4 1 Checks 4 1 1 Safety features cells gate contact Check for correct operation every 6 months 4 1 2 Backup battery For optimum battery life it is recommended that the main power supply be switched off and the motor operated using the battery for several cycles three times a year 4 Copyright© 2018 SOMFY ACTIVITES SA All rights reserved Dexxo Smart io EN