Der Blätterkatalog benötigt Javascript.
Bitte aktivieren Sie Javascript in Ihren Browser-Einstellungen.
The Blätterkatalog requires Javascript.
Please activate Javascript in your browser settings.
16 EN Copyright © 2018 SOMFY ACTIVITES SA Société Anonyme All rights reserved ILMO 2 40 WT 2 3 COMMISSIONING After having affixed the roller shutter to the roller tube check that when the roller shutter is in the lower end limit position the rigid link is correctly positioned and that the first slat is vertically between the runners as per F If necessary adjust the number of slats used to improve the position of the rigid link when the roller shutter is in the lower end limit position Always refer to the manufacturer s size and weight charts and fitting recommendations for the rigid links to select those suited to the roller shutter used Use at least 2 rigid links to attach the roller shutter to the roller tube 1 Switch the power back on - Press the Up button at the control point - If the roller shutter rises the wiring is correct and commissioning is finished - If the roller shutter is lowered go to the next step 2 Switch off the power - Reverse the brown wire and the black wire connected to the control point 3 Switch the power back on - Press the Up button to check the direction of rotation 2 4 TIPS AND RECOMMENDATIONS FOR INSTALLATION 2 4 1 Questions concerning the ILMO 2 40 WT? Problems Possible causes Solutions The roller shutter is turning in the wrong direction The wiring is incorrect Check the wiring and modify it if necessary The roller shutter is not operational The wiring is incorrect Check the wiring and modify it if necessary The drive is hot Wait for the motor to cool down The control point is not compatible Check for compatibility and replace the control point if necessary The roller shutter stops too soon The roller shutter is encountering friction when it moves friction along the runners and case interference between the roller tube and the drive etc Check the roller shutter installation and correct any friction If the problem continues restore the drive to its original configuration The drive has been installed in a new roller shutter Restore the drive to its original configuration see the section entitled Restoring the original configuration The roller shutter does not stop when it reaches the lower end limit position The mountings used are not correct Check that the roller shutter is mounted to the roller tube using rigid links The roller shutter does not stop when it reaches the upper end limit position The roller shutter locking system in the upper position is not correct Check that the roller shutter is fitted with end stops screwed onto the last slat fixed or removable stops incorporated in the runners or an end slat acting as an end stop F F 1 2 3 ON ON OFF OK 2 OK